Check the forms that hold the concrete to see that they are poorly constructed Set the forms that hold concrete to the desired pitch and depth, align them Spread level and smooth concrete using rake shovel hand or power trowel hand or powered screed and float <old expansion joints and edges using edging tools jointers and straight edge Monitor how the wind heat or cold affect the curing of the concrete throughout the entire process Signal truck driver to position truck to facilitate pouring concrete and move chute to direct concrete on forms. Produce rough concrete surface using broom Operate power vibrator to compact concrete Direct the casting for the concrete and supervise laborers who use shovels using hoe trowel tamper scraper or concrete mixing machine. Cut out damaged areas, drill holes for reinforcing rods and position reinforcing rods to repair concrete using power saw and drill Wet concrete surface and rub with stone to smooth surface and obtain specified finish Wet surface to prepare for bonding fill holes and cracks with grout or slurry and smooth using trowel Clean chipped area using wire brush and feel and observe surface to determine if its rough or uneven Apply hardening and sealing compounds to cure surface of concrete and waterproof and restore surface Chip scrape and grind high spots ridges and rough projections to finish concrete using pneumatic chisels power grinds or hand tools Build wooden molds and clamp molds around area to be repaired using hand tools Sprinkle colored marble or stone chips powdered steel or coloring powder over surface to produce prescribed finish Fabricate concrete beams column s and panels

Waterproof or restore concrete surfaces using appropriate compounds pattern or stamp the surface to provide a decorative finish Apply uriatic acid t clean surface and rinse with water Push roller over surface to embed chips in surface Polish surface using polishing or surfacing machine. OSHA 10 hour, 3 years experience e and drivers license needed.